System Setting; Date/Time - EverFocus EMV400S FHD User Manual

7.3.9

System Setting

You can configure the general settings for the mobile DVR in this menu.

7.3.9.1 Date/Time

You can set up the date and time for the mobile DVR.
Note: Clicking Save at this page will disable the Daylight Saving function if this function has
been enabled. Therefore, after setting up the time at this page, you need to go to Daylight
Saving page to reset and enable the daylight saving time if the function is needed. Please refer
to 7.3.9.2 Daylight Saving for detailed information.
Date: Click to set up the date.
Time: Click to set up the time.
Date Format: Select a date format from the drop-down list.
Time Format: Select a time format from the drop-down list.
Time Zone: Select a time zone for the mobile DVR to adjust to when updating from the time
server.
Time Sync: You can synchronize the MDVR time with NTP server or GPS time.
Disable: Select to disable the time synchronization function.

NTP: Select to synchronize the MDVR time with NTP server. You will have to further set up

the NTP Server and NTP Update Interval settings below.
GPS: Select to synchronize the MDVR time with GPS time. For this function to work, a GPS

antenna is required to connect to the MDVR to receive GPS signal.
NTP Server: If NTP is selected from the Time Sync drop-down list above, you will have to
further select a NTP Server. The NTP Server displays the time server address that the mobile
DVR uses for time synchronization. For this function to work, operating network configuration
and WAN or LAN access to a compatible NTP server is required. The default NTP address is the
EMV400S FHD / EMV400SSD Mobile DVR
196