G-Sensor Event - EverFocus EMV400S FHD User Manual

6.4.5

G-Sensor Event

You can configure the gravity value of the X, Y and Z-axial, once the vehicle reach the setup
value, the alarm will be triggered.
G-Sensor: Select On / Off to enable / disable G-Sensor function.
Email Notify: Check box to enable email notification when GPS is lost. Email operation
requires valid email settings entered in the Email setup screen (see 6.7.4 Email).
Network Alarm: Check box to send out a network alarm to the client PC. This feature works
with EverFocus' CMS software. You will need to configure the Alarm Server for mobile DVR
to send network alarms to the client PC (see 6.7.7 Alarm Server).
XY Axial Trigger Value: Set XY Axial trigger value, alarm will be triggered when acceleration
reaches this value in horizontal direction with respect to the horizon. The available setup
value is between 0 ~127 (1000mg = 1 Gravity).
Z Axial Trigger Value: Set Z Axial trigger value, alarm will be triggered when vertical
acceleration reaches this value. The available setup value is between 0 ~127 (1000mg = 1
Gravity).
Alarm Output: This will transmit a signal through the alarm output relay. It can be set to
either "NONE" (not active), "1" (active) or "2" (active).
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will be continuously active until user presses the "Enter" key or
resets the alarm remotely.
Transparent: Alarm output remains active until event ends.
EMV400S FHD / EMV400SSD Mobile DVR
85