EverFocus EMV400S FHD User Manual page 100

6.4.6.5 Unmount SD
This function is only available for EMV400SSD.
Log: Check the box to record alarm events to log data.
Buzzer: The buzzer will activate when SD card is unmounted.
Email Notify: Check the box to send email notification when SD card is unmounted. Email
operation requires valid email entered in the Email setup menu (see 6.7.4 Email).
Network Alarm: Check the box to send out a network alarm to a client PC when SD card is
unmounted. This feature works with EverFocus' CMS software. You will need to configure the
Alarm Server for the mobile DVR to send network alarms to the client PC (see 6.7.7 Alarm
Server).
Send to Xfleet: Check the box to send the event data to the Xfleet system. Note that for the
Xfleet system to receive event data from the mobile DVR in order to perform the event actions
on Xfleet system, this function must be enabled.
Alarm Output: Select an alarm output number. When an alarm is triggered, the signal will be
transmitted through the selected alarm output relay.
Output Type: Select an output type when SD card is unmounted.
Timeout: Select this option and then set up the Timeout Duration in the field below, the
alarm output will last for the setup duration time (10 ~ 150 seconds).
Permanent: Alarm will remain active until the user presses the "Enter" key on the IR
Remote Control or resets the alarm remotely.
Transparent: Alarm output remains as long as the alarm input is active.
Trans + Timeout: Alarm output continues until event ends, then continues for the setup
duration time (10 ~ 150 seconds).
Timeout Duration: This function only appears when you select Timeout or Trans + Timeout
options in the Output Type drop-down list. Select a duration time for the event. The alarm
output will last for the setup duration time between 10 and 150 seconds.
Save: Click to save the settings.
EMV400S FHD / EMV400SSD Mobile DVR
91