Toyota LAND CRUISER Service Manual Supplement page 63

MT-34
MANUAL TRANSMISSION (STATION WAGON) - OUTPUT SHAFT
(c) Using a feeler gauge, measure the clearance between the
synchronizer ring back and the gear spline end.
Minimum clearance:
1st gear
3rd and 5th gear
HINT:
• When replacing either a synchronizer ring or gear, ap-
ply a small amount of fine lapping compound between
the synchronizer ring and gear cone.Lightly rub the
synchronizer ring and gear together.
• When replacing both the synchronizer ring and gear,
there is no need to apply any compound or to rub them
together.
NOTICE: Wash off completely the fine lapping com-
pound after rubbing.
3. INSPECT SYNCHRONIZER RING
H150F - FOR SECOND GEARS
H1 51F - FOR FIRST SECOND AND THIRD GEARS
(a) Check for wear or damage.
(b) Check the braking effect of the synchronizer direction
while pushing it to the gear cone and check that the ring
is locked. If the braking effect is insufficient, replace the
synchronizer ring.
(c) Measure the clearance between the synchronizer ring
back and gear spline end.
Minimum clearance:
1st and 2nd gear
3rd gear
If the clearance is less than the limit, replace the synchro-
nizer ring.
4. INSPECT CLEARANCE OF SHIFT FORKS AND HUB
SLEEVES
Using a feeler gauge, measure the clearance between the
hub sleeve and shift fork.
Maximum clearance:
0.35 mm (0.0138 in.)
If the clearance exceeds the maximum, replace the shift
fork or hub sleeve.
1.1 mm (0.0433 in.)
0.8 mm (0.0315 in.)
0.85 mm (0.0335 in.)
0.75 mm (0.0295 in.)