AUTOMATIC TRANSMISSION (STATION WAGON)
AT-70
7.
REMOVE NO.1 SPEED SENSOR CONNECTOR
8.
REMOVE FRONT AND REAR PROPELLER SHAFTS
(See Pub. No. RM184E, page PR-3)
9.
(w/ MECHAICAL WINCH)
REMOVE POWER TAKE OF SHIFT CABLE
(a)
Pull out the pin and disconnect the cable.
(b)
Remove the t w o bolts and the cable bracket.
(c)
Remove the engine under cover.
(d)
Place matchmarks on the yoke and flange.
(e)
Remove the bolts and nuts, disconnect the drive shaft
from the PTO.
(f)
Remove the front and rear bracket set bolts, and then re-
move the drive shaft.
10. REMOVE OIL FILLER TUBE
(a)
Remove the level gauge.
(b)
Remove the bolt.
ASSEMBLY REMOVAL
AND INSTALLATION