Toyota LAND CRUISER Service Manual Supplement page 59

MT-30
MANUAL TRANSMISSION (STATION WAGON) - OUTPUT SHAFT
OUTPUT SHAFT DISASSEMBLY
1. INSPECT EACH GEAR THRUST CLEARANCE
Measure the thrust clearance of each gear.
Standard clearance:
1st and 3rd gear
2nd and 5th gear
Maximum clearance:
1 st and 3rd gear
2nd and 5th gear
2. INSPECT EACH GEAR OIL CLEARANCE
Using a dial indicator, measure the oil clearance of each
gear.
Standard clearance:
1st and 3rd gear
2nd and 5th gear
Maximum clearance:
1st and 3rd gear
2nd and 5th gear
3. REMOVE BALL BEARING AND FIRST GEAR
(a) Using two screwdrivers and a hammer, drive out the
snap ring.
(b) Remove the thrust washer and pin.
(c) Using SST and a press, remove the ball bearing, thrust
washer, first gear and synchronizer ring.
H150F — Single Synchronizer ring
H1 51F — Triple Synchronizer rings
SST 09555-55010
(d) Remove the pin and needle roller bearing.
0.1 — 0.45 mm
(0.0039 - 0.0177 in.)
0.1 — 0.35 mm
(0.0039 - 0.0138 in.)
0.45 mm (0.0177 in.)
0.35 mm (0.0138 in.)
0.020 — 0.073 mm
(0.0008 - 0.0029 in.)
0.015 — 0.068 mm
(0.0006 - 0.0027 in.)
0.073 mm (0.0029 in.)
0.068 mm (0.0027 in.)