Saeco SUP040RB Operation And Maintenance page 103

English
Warning Signals How to reset the message
The selected operation requires milk dispensing.
Insert the previously removed valve in the Cappuccinatore as described in the manual.
Fill the coffee bean hopper with coffee beans.
The machine requires a descaling cycle.
When this message is displayed, it is still possible to use the machine, but its correct operation
might be affected.
Damage caused by failure to descale the machine is not covered by warranty.
The machine indicates that the "Intenza" water filter should be replaced with a new one.
Contact the service provider.
The machine indicates that after a few cycles it will be necessary to empty the coffee grounds
drawer (see section "Emptying the Coffee Grounds Drawer").
This message does not prevent the machine from brewing further products.
Remove the coffee grounds drawer and empty the coffee grounds into a suitable container.
NOTE:
the coffee grounds drawer must be emptied only when indicated by the machine and with the machine turned
on and/or in stand-by mode.
If the drawer is emptied with the machine turned off, the machine will not record the emptying operation.
Flashing red LED light.
Machine in Stand-by.
The Stand-by settings can be changed (contact the service provider).
Press the "Stand-by" button.
An event has occurred which requires the machine to be restarted.
Take note of the code (E xx) shown at the bottom.
Turn off the machine, wait for 30 seconds and then turn it on again.
If the problem persists, contact the service centre.
If this screen is displayed after starting the machine, a descaling cycle should be run.
Contact the service provider.
Please note that damage caused by failure to descale the machine is not covered by warranty.
103