Motorola HT 1000 User Manual page 111

Sticky Revert
Sticky Revert Alert
Call Alert
Rx Call Alert Light
Rx Select Call Light
This feature is limited to HT 1000 "B" models and VISAR models with
firmware version 2.06 or later. If this field is enabled on a radio having an
earlier version firmware, it will have no effect.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, the radio will operate in Sticky Channel Revert
mode when in an MDC Emergency state. Sticky Revert is characterized
by the radio remaining permanently on the Revert channel after the
MDC Emergency message has been transmitted and acknowledged.
The radio must be powered off and on in order to return to normal
channel control.
Note: The MDC/STAR/ATIS Decode field on the CHANNEL
CONFIGURATION screen (F4/F4) must be set to Enabled. Only then
will the radio be able to decode the Emergency Acknowledgment that
is generated from the MDC fixed equipment. This feature needs to
be enabled only on the Emergency Revert channel and only
when Emergency Revert or Sticky Revert is in use.
The default is Disabled.
This feature is limited to HT 1000 "B" models and VISAR models with
firmware version 2.06 or later. If this field is enabled on a radio having an
earlier version firmware, it will have no effect.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, an alert tone will be generated if PTT is pressed
when the radio is on the Sticky Revert Channel. It reminds the user
that the radio is transmitting on a channel different from the one
indicated by the Channel Selector knob. On VISAR models alone, the
display will correctly indicate the Sticky Revert Channel.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this option. This per-
radio feature is a convenient way for the dispatcher to page a radio
user. If this feature is enabled, the radio will emit a continuous series
of four beeps and the LED will flash green when a Call Alert (page) is
received. The alert will continue until the user acknowledges the page
and presses the PTT button, or presses and releases the Monitor
button.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, the radio's LED will flash green when a Call Alert
(page) is received.
The default is Enabled.
Use the UP/DOWN arrow keys to enable/disable this option. If this
feature is enabled, the Receive Select Call LED will light up when a
Select Call is received and flash for the entire length of the message.
The Select Call refers to Quik-Call II, MDC and ATIS Select Call.
The default is Enabled.
105