Check The Included Items; Connect To The Computer - Roland Stika Plus STX-8 User Manual

How to use this manual
In this manual, the names of the products covered appear as
follows. STIKA PLUS STX-8
STIKA PLUS STX-8 = STX-8
STIKA STX-7 = STX-7
The illustrations appearing in this manual depict the STX-8. The STX-7 may differ from the product shown.
1

Check the included items

Roland Software Package : 1
Material for test cuts : 1
* Paper : 1
* Included only with the STX-8.
2
Installing and Connecting to the Computer
Do not use with any power supply
other than the dedicated AC adapter.
Use with any other power supply may lead
to fire or electrocution.
NOTICE
Never install this unit in any of the following situations, as it could result in damage:
• Places where the installation surface is unstable or not level.
• Places with excessive electrical noise.
• Places with excessive humidity or dust.
• Places with poor ventilation, because the STX-8/7 generates considerable heat during operation.
• Places with excessive vibration.
Use within a temperature range of 5 to 40°C (41 to 104°F) and within a humidity range of 35 to 80%.
Make sure the power to the computer and the STX-8/7 is switched off before attempting to connect the cables.
Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged. Otherwise,
faulty operation or breakdown may result.
AC adapter : 1
Application tape for test cuts : 1
STX-8/7 User's Manual : 1
Sections that describe identical procedures for the two models are
indicated as follows.
STX-8/7
* The blade holder and blade are installed on
the unit when shipped from the factory.
Blade holder : 1
* Sheet setup guide : 1
The configuration of the AC adapter varies according to
regional differences in voltage. Please note that the
descriptions in this manual are for the 117 V adapter.
Install on a stable surface.
Failure to do so
may result in
falling of the unit,
leading to injury.
Blade : 1
* Water based fiber tipped pen : 1
3