Basic Operation; Setting Up And Connection - Roland CAMM-1 User Manual

3 Basic Operation

3-1 Setting Up and Connection

When arranging setup space for the PNC-960, make sure you have a space that is at least 950 mm (37-7/16") wide, 500 mm (19-11/
16") in depth, and 230 mm (9-1/16") in height. For the PNC-910, a space that is at least 650 mm (25-5/8") wide, 500 mm (19-11/16")
in depth, and 230 mm (9-1/16") in height.
Since the material moves during cutting, make sure the unit is placed on a stable, sturdy surface. Also make sure there is nothing that
can block the material at both front and rear.
- Do not try to pick up or move the PNC-960/910 by grasping the top area of the unit. Be sure to use both hands to grip the PNC-
960/910 securely on the left and right sides.
- Connect the cable to either the parallel or the serial port. Be sure that the power to both the computer and the main unit is
switched off when connecting the cable.
- Avoid places subject to strong electrical noise.
- Avoid excessively dusty or damp places.
- Never leave the unit in a place that is subject to direct sunlight, or where the temperature could go to extremes.
- Since it is normal for this device to emit heat when in operation, never place it where it is poorly ventilated and such heat cannot
dissipate.
Power cord
* Cables are available separately. One which you are
sure matches the model of computer being used
should be selected.
Power outlet
Power connector
Serial input connector
Parallel input connector
Serial interface cable
(Connect to the serial input port.)
Parallel interface cable
(Connect to the parallel input port.)
* When the PNC-960/910 is connected to the computer via the serial
port, the communication parameters (Baud, Data, Parity, Stop,
etc.) for the PNC-960/910 need to match the port settings on the
computer. Use the DIP switches on the right-hand side of the PNC-
960/910 to make these settings. Refer to "3-2 DIP Switch
Settings" to make the correct settings.
3 Basic Operation
Serial connector
or
Parallel connector
3