HP A5830 series Configuration Manual page 143

[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local
[SwitchB-Vlan-interface2] ipv6 address 1::2 64
# Create a VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10
# Configure Switch B to work in preemptive mode, with the preemption delay set to 5 seconds.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
# Enable Switch B to send RA messages, so that Host A can learn the default gateway address.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
Verify the configuration.
3.
After the configuration, Host B can be pinged successfully on Host A. To verify your configuration, use
the display vrrp ipv6 verbose command.
# Display the detailed information of VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
# Display the detailed information of VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: FE80::10
1::10
: 0000-5e00-0201
: FE80::1
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 4200ms left
: None
: FE80::10
1::10
: FE80::1
143
: 100
: Master
: 110
: 5
: 100
: Backup
: 100
: 5