Rrppdus - HP A5830 series Configuration Manual

As shown in
of Ring 1, and Device B, Device C, and Device D are the transit nodes of Ring 1. Device E is the master
node of Ring 2, Device B is the edge node of Ring 2, and Device C is the assistant-edge node of Ring 2.
Primary port and secondary port
Each master node or transit node has two ports connected to an RRPP ring, one serving as the primary
port and the other serving as the secondary port. You can determine the port's role.
In terms of functionality, the primary port and the secondary port of a master node have the
•
following differences:
The primary port and the secondary port are designed to play the role of sending and receiving
loop-detect packets, respectively.
When an RRPP ring is in Health state, the secondary port of the master node will logically deny
data VLANs and permit only the packets of the control VLANs.
When an RRPP ring is in Disconnect state, the secondary port of the master node will permit
data VLANs (forward packets of data VLANs).
In terms of functionality, the primary port and the secondary port of a transit node have no
•
difference. Both are designed for transferring protocol packets and data packets over an RRPP ring.
As shown in
and the secondary port of the master node on Ring 1, respectively. Device B, Device C, and Device D
are the transit nodes of Ring 1. Their Port 1 and Port 2 are the primary port and the secondary port on
Ring 1, respectively.
Common port and edge port
The ports connecting the edge node and assistant-edge node to the primary ring are common ports. The
ports connecting the edge node and assistant-edge node only to the subrings are edge ports.
As shown in
and Device C's Port 1 and Port 2 access the primary ring, so they are common ports. Device B's Port 3
and Device C's Port 3 access only the subring, so they are edge ports.
RRPP ring group
To reduce Edge-Hello traffic, you can configure a group of subrings on the edge node or assistant-edge
node. For more information about Edge-Hello packets, see "RRPPDUS." You must configure a device as
the edge node of these subrings, and another device as the assistant-edge node of these subrings.
Additionally, the subrings of the edge node and assistant-edge node must connect to the same subring
packet tunnels in major ring (SRPTs) so that Edge-Hello packets of the edge node of these subrings travel
to the assistant-edge node of these subrings over the same link.
An RRPP ring group configured on the edge node is an edge node RRPP ring group, and an RRPP ring
group configured on an assistant-edge node is an assistant-edge node RRPP ring group. Up to one
subring in an edge node RRPP ring group is allowed to send Edge-Hello packets.

RRPPDUS

Table 18 RRPPDU types and their functions
Type
Hello
13, Ring 1 is the primary ring and Ring 2 is a subring. Device A is the master node
Figure
13, Device A is the master node of Ring 1. Port 1 and Port 2 are the primary port
Figure
13, Device B and Device C lie on Ring 1 and Ring 2. Device B's Port 1 and Port 2
Figure
Description
The master node initiates Hello packets to detect the integrity of a ring in a
network.
56