To specify a master node:
To do...
•
Enter system view
•
Enter RRPP domain view
•
Specify the current device as
the master node of the ring,
and specify the primary port
and the secondary port
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
To specify a transit node:
To do...
•
Enter system view
•
Enter RRPP domain view
•
Specify the current device as
a transit node of the ring, and
specify the primary port and
the secondary port
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
To specify an edge node:
To do...
•
Enter system view
•
Enter RRPP domain view
•
Specify the current device as
a transit node of the primary
ring, and specify the primary
port and the secondary port
•
Specify the current device as
the edge node of a subring,
and specify the edge port
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring
the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode master [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
Use the command...
system-view
rrpp domain domain-id
ring ring-id node-mode transit [
primary-port interface-type
interface-number ] [ secondary-
port interface-type interface-
number ] level level-value
ring ring-id node-mode edge [
edge-port interface-type interface-
number ]
66
Remarks
—
—
Required
Remarks
—
—
Required
Remarks
—
—
Required
Required