Figure 19 Schematic diagram for an intersecting-ring load balancing network
Protocols and standards
RFC 3619 Extreme Networks' Ethernet Automatic Protection Switching (EAPS) Version 1 is related to
RRPP.
RRPP configuration task list
You can create RRPP domains based on service planning, specify control VLANs and data VLANs for
each RRPP domain, and then determine the ring roles and node roles based on the traffic paths in each
RRPP domain.
Complete the following tasks to configure RRPP:
Task
Creating an RRPP domain
Configuring control VLANs
Configuring protected VLANs
Configuring RRPP
rings
Activating an RRPP domain
Configuring RRPP timers
Configuring RRPP ports
Configuring RRPP nodes
Remarks
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain.
Required
Perform this task on all nodes in the RRPP domain
Required
Perform this task on all nodes in the RRPP domain.
Optional
Perform this task on the master node in the RRPP domain.
62