Network Setting - Canon ScanFront 400 Instructions Manual

3.
Select the setting item to configure.
❏ Network Setting
Configure the device name and IP address used for
connecting the ScanFront to a network with [Network
Setting] of the Device Configuration screen.
IMPORTANT
• Configure network settings while the network cable is
connected to the scanner. If the network cable is not
connected to the scanner, you will not be able to verify or
modify settings in the network settings screen.
• The device name is the name for the scanner used on the
network. When changing this setting, make sure to select a
unique name that is different from those of all other devices.
• The device name can be a combination of letters (A-Z, a-z),
numbers (0-9), and hyphens (-) up to 15 characters long.
• The device name must begin with a letter. You cannot end the
device name with a hyphen.
• When a DHCP server is not used to assign IP addresses,
clear the [DHCP server Enable] check box, and enter a fixed
address. For details, contact your network administrator.
35
Chapter 2 ScanFront Setup