Setting The Long Document Mode - Canon imageFORMULA DR-C225 II User Manual

Scanner driver (Windows)
Configure the following settings in the [Basic] tab. (" Confirming Basic
Conditions for Scanning" on p.62 )

Set [Page Size] to half the size of the document (set to [Match original
size] when scanning an atypical document size)

Set [Scanning Side] to [Folio].
Scanner driver (OS X/macOS)
Configure the following settings. (" Page Size" on p.64)

Set [Page Size] to half the size of the document (set to [Detect
automatically] when scanning an atypical document size)

Set [Scanning Side] to [Folio].

Setting the Long Document Mode

The length of documents that can be scanned with the scanner is
normally 356 mm (14" ), but you can scan documents up to 3,000 mm
(118.1" ) long by setting the scanner to the Long Document mode.
Note the following when using the Long Document mode:

When scanning in the Long Document mode, if the document
is placed on the scanner in a skewed position, it may hit the
edges of the feeding area and be damaged. Be careful to place
the document so that it is not skewed.

When scanning with the Long Document mode, paper jam
detection may react slowly, resulting in damage to the
document. Be careful to avoid paper jams.

When scanning long documents, make sure to set the feed
selection lever to the non separation position, and scan the
documents one at a time.

When scanning large-sized documents with the Long
Document mode, scanning may be slower. Errors may also
occur due to memory shortage and scanning may be disabled.

Scanning in the Long Document mode is supported only
during USB connections.
1
Start Windows and log in as a user with administrator privileges.
2
Click the Start button, and then click [All Programs], [Canon
DR-C225], and [Canon imageFORMULA Utility].
imageFORMULA Utility starts.
32