Denso BHT-7000 User Manual page 99

If an error occurs during uploading
If some error occurs during uploading, one of the following screens will appear and
the beeper beeps three times.
To retry the uploading operation, press the 1 and ENT keys; to abort it, press the 2
and ENT keys.
Press the C key to return to the SYSTEM MESSAGE menu.
UPLOAD
Out of memory!!
UPLOAD
Too many files!!
UPLOAD
_SYSMSG.FN3
Communication error!!
Retry!
1:Yes 2:No
Chapter 2. Getting Started the BHT-7000 and System Mode
Problem
The memory is insufficient for setting up the sys-
tem message file.
Solution
Press the C key to return to the SYSTEM MENU,
then delete unnecessary files in the memory. (Re-
fer to Subsection 2.6.3, [ 7 ].
Problem
The memory has already contained 80 files, so the
BHT system message file cannot be set up.
Solution
Press the C key to return to the SYSTEM MENU,
then delete unnecessary files in the memory. (Re-
fer to Subsection 2.6.3, [ 7 ].
Problem
Uploading has failed.
Solution
To retry uploading, press the 1 key.
To return to the SYSTEM MENU, press the 2 key.
Check the interface port, communications param-
eters, and communications protocol type in the
SET SYSTEM menu or perform the communica-
tions test in the TEST menu. (Refer to Subsection
2.6.3, [4.5] and [5.7].)
It is also necessary to check the communications
parameters setup of the host computer.
83