Denso BHT-7000 User Manual page 28

System Mode
System Mode is a system program exclusively designed for the effective use of user
programs in the BHT-7000. It sets up the execution environments for those programs;
e.g., it prepares downloading/uploading conditions, sets the calendar clock, and tests
the BHT-7000 components including the LCD, beeper, and keypad. Shown below is the
System Mode menu (SYSTEM MENU).
JIS Level 1 and Level 2 Font Files
These files contain font data required for displaying Kanji characters on the LCD.
The BHT-7000 can display the Kanji characters not only in the conventional standard-
size font (16 dots wide by 16 dots high) but also in the small-size font (12 dots wide by
12 dots high) in application programs. It can also display the double-width Kanji
characters of those 16-dot and 12-dot fonts in application programs.
If you do not need to display Kanji characters, you may delete these JIS font files.
After deletion, the memory area which was occupied by these files can be used as a
user area. For the deleting procedure, refer to Section 2.5, "Initializing the BHT-
7000 System" or Subsection 2.6.3, "[ 7 ] Deleting Files."
The names of the JIS font files are:
FNT16J1.FN3
FNT16J2.FN3
FNT12J1.FN3
FNT12J2.FN3
User Programs
You can develop application programs to meet individual job requirements by using
the BHT-BASIC Compiler. To download those user programs to the BHT-7000, use Ir-
Transer Utility C/Ir-Transfer Utility E/Transfer Utility.
SYSTEM MENU
1:EXECUTE PROGRAM
2:DOWNLOAD
3:UPLOAD
4:SET SYSTEM
5:TEST
6:VERSION
(JIS Level 1 font, 16-dot)
(JIS Level 2 font, 16-dot)
(JIS Level 1 font, 12-dot)
(JIS Level 2 font, 12-dot)
12