Denso BHT-7000 User Manual page 37

• Before battery replacement, be sure to turn the BHT off. Within three minutes
from the removal of the battery cartridge, load the battery cartridge to avoid
data loss. After battery replacement, turn the BHT on and check its operation.
• When replacing dry batteries, always replace both of them with new alkaline
manganese batteries (LR6).
• You may charge the lithium-ion battery cartridge with the optional CU-7000
communications unit or optional C-700/C-750 charger. For the charging pro-
cedure using the CU-7000, refer to Chapter 5. For that using the C-700/C-750,
refer to the "C-700 User's Manual"/"C-750 User's Manual."
• If the "Charge the battery!" or "Replace the batteries!" message appears after
the BHT undergoes any shock or impact, turn the power off and on and then
check the battery output level. The battery may not have run out.
WARNING
Never charge a wet or damp battery cartridge.
CAUTION
Doing so could cause the batteries to break, gen-
erate heat, rupture or burn.
Chapter 2. Getting Started the BHT-7000 and System Mode
Only use the dedicated charger (CU-7000, C-700,
or C-750) for charging the lithium-ion battery
cartridge.
Using a different type of charger could cause
battery-rupture or leakage of battery fluid and
result in a fire, bodily injury, or serious damage
to property.
21