Table of Contents
Advertisement
[4.5-4] Setting the communications protocol type
PROTOCOL TYPE
1:BHT Protocol
2:BHT-Ir Protocol
SET ID
00001 >> _
SET ID
00001 >> 65535_
* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of
, and
keys, respectively
Chapter 2. Getting Started the BHT-7000 and System Mode
Selecting the "4:PROTOCOL TYPE" on the SET
COMMUNICATION menu calls up the screen shown
at left.
Highlighted is the current setting.
1 BHT Protocol:
2 BHT-Ir Protocol: Selects the BHT-Ir protocol for
Select a desired item by using the numerical keys
or
* and
* keys, and then press the ENT
key.
To return to the SET COMMUNICATION menu,
press the C key.
Selecting the "2:BHT-Ir Protocol" on the PROTO-
COL TYPE screen calls up the screen shown at left.
Enter the ID number of the BHT by using the nu-
merical keys, and then press the ENT key. If
you do not need to modify the current setting,
press the ENT key only.
An ID number should be five-digit decimal
character string. The entry range is from
00001 to 65535. If the entry value is less
than five digits, the ENT key will be deacti-
vated.
If you make a wrong entry, press the BS key to
delete it and then enter the correct data.
To return to the SET COMMUNICATION menu,
press the C key.
57
Selects the BHT-protocol for
downloading or uploading
files in System Mode or for
the execution of XFILE state-
ment in BHT-BASIC.
This protocol should be se-
lected for file transmission
with Transfer Utility.
downloading or uploading
files in System Mode or for
the execution of XFILE state-
ment in BHT-BASIC.
This protocol should be se-
lected for file transmission
with Ir-Transfer Utility C/Ir-
Transfer Utility E.
,
,
Advertisement
Chapters
Table of Contents
