Table of Contents
Advertisement
If the IP is successfully configured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of Managed Switch
through the new IP address.
If you are not familiar with console command or the related param-
eter, enter "help" anytime in console to get the help description.
Note
4.3 Setting 1000BASE-X for 10G SFP+ Port
The Managed Switch supports both 1000BASE-X and 10GBASE-X SFP
transceivers by manual setting and the default SFP+ port speed is set to 10Gbps.
For example, to establish the fiber connection with 1000BASE-X SFP transceiver in
the tgigaethernet 0/1, the following command configuration is required:
Switch#config
Switch_config#interface tgigaethernet 0/1
Switch_config_tg1/1#speed 1000
Switch_config_tg1/1#exit
Switch_config#interface range tgigaethernet 0/2-24
Switch_config_if_range#speed 1000
Switch_config_if_range#
Figure 4-6 Setting 1000BASE-FX Screen
9
Advertisement
Table of Contents
