Table of Contents
Advertisement
7. Setting 1000BASE-X for SFP+ Port
The Managed Switch supports both 10GBASE-X SFP+ transceiver and
1000BASE-X SFP transceiver by manual setting and the default SFP+ port
speed is set to 10Gbps. To establish the fiber connection with 1000BASE-X SFP
transceiver, the following command configuration is required:
XGS3-24042#config
XGS3-24042(config)#interface ethernet 1/0/25-28
XGS3-24042(config-if-port-range)#speed-duplex force1g-full
8. Setting 100BASE-FX for SFP Port
The Managed Switch supports both 1000BASE-X and 100BASE-FX SFP
transceivers by manual setting and the default SFP port speed is set to 1000Mbps.
To establish the fiber connection with 100BASE-FX SFP transceiver, the following
command configuration is required:
XGS3-24042#config
XGS3-24042(config)#interface ethernet 1/0/21-24
XGS3-24042(config-if-port-range)#speed-duplex force100-fx
10
Figure 7-1 Setting 1000BASE-X Screen
Figure 8-1 Setting 100BASE-FX Screen
Advertisement
Table of Contents
