Honeywell NEXPTZ-PD Installation And Operation Manual page 4

Methods of Installation
To install this product, please refer to Figure2 and do the following steps.
1. Make sure the threads of the product and the threads of the supplied M8X15mm stainless steel bolts
(Supplied) are free of dirt and debris.
2. Apply an amount of thread locking compound(not supplied) to the thread of the product and the thread of
the bolts.
3. Secure the product to the mounting surface with the adjusted wrench and four M8x15mm stainless steel
bolts and lock washers. Tighten the bolts to 250~350 kgf.cm (24Nm~34Nm)
Note : Figure2 shows the product being installed on a Pedestal mount which is an optional
product (not supplied) and if there is no need the pedestal mount, just follow a above step to install
the product without pedestal mount bracket.
Figure2.
Install the product to Pedestal Mount bracket
- 4 -