Honeywell NEXPTZ-PD Installation And Operation Manual page 20

Program and Operation
1.4 PATTERN (MENU => Function => Pattern ; Short cut : PATTERN)
The Pattern function stores user's control of the selected dome camera for up to 240 seconds.
4 patterns can be stored in 240 seconds of total recording space. Stored pattern is played back
by pressing No.+ Pattern buttons subsequently
Follow the steps below to program the Pattern:
1. Select the camera number by pressing 0 ~9 and CAM.
2. Simply press the Pattern key. (or MENU => Function =>Pattern)
3. Select the empty Pattern number to be programmed by pushing the Joystick Up or Down. If
SEC column is not 000, then the selected No. of pattern is already recorded.
4. Twist the Joystick to enter recording mode and control the camera direction and zoom with
the Joystick. Your controls will be automatically recorded. You can repeat this procedure
until you are satisfied with the pattern recorded.
to start PTZ control for view selection and hit the Focus button to stop.)
5. Scroll down to the Save and Exit option and push the Joystick to the right to save and exit.
6. You can title the selected Pattern by pushing the Joystick to the left or right. Rotate the
handle clockwise or counterclockwise to scroll through the alphanumeric characters, push
the handle to right or left to select next or previous space.
7. Pressing ESC will not save currently recorded data and exits to the previous menu mode.
Press the HOME or OFF button at any programmed position to delete the programmed
pattern.
NOTE: If total recording time reaches 240 seconds, it will automatically stop.
Pattern Setup
NO TILTIE
O1 : PATTERN1
O2 : PATTERN2
O3 : PATTERN3
O4 : PATTERN4
TOTAL:
071
Save And Exit
- 20 -
SEC
000
041
010
020
(Or twist zoom handle or hit zoom button