Honeywell NEXPTZ-PD Installation And Operation Manual page 21

Program and Operation
2. ALARM
Locate the cursor on ALARM item in the main menu and push the joystick to the right for ALARM
programming of the camera.
No : Alarm input number
Fun : Priority 1~8calls Preset(xxx),
: Priority 0 supports dedicated functions like a Pattern(Pxx), Tour(Txx), Scan(Sxx).
Pri(Priority) : Lower No. has higher priority, Equal priority alarms will be serviced repeatedly.
In : NO/NC - normally open /Closed, OFF - ignore
: RO1 - Relay out 1, RO2 – Relay out2
Out
Hld(Hold) : Alarm will be held for programmed time (01 to 255 seconds)
Latch : ON - Shows all alarms including past alarm, OFF - Shows activated alarms only.
There are 9 levels of priority. 0 : Highest priority supports repeated/dedicated functions like a
Pattern(Pxx), Tour(Txx), Scan(Sxx). 1~8: Same level of alarm calls presets one after the other.
Main Menu
Function
Alarm
Screen
Camera
Setup
Password
Communication
Run Function
Exit
Alarm Setup
No Fun Pri In
01 001 3 OFF OFF 001
02 002 3 OFF OFF 001
03 003 3 OFF OFF 001
04 004 3 OFF OFF 001
Save And Exit
- 21 -
Out Hld Latch
OFF
OFF
OFF
OFF
OFF - No output.