Honeywell NEXPTZ-PD Installation And Operation Manual page 19

Program and Operation
Follow the steps below to program the Tours:
1. Press MENU => Function => TOUR (Short Cut: TOUR) to display the main menu on the
monitor. No. + SHFT+TOUR will open directly Tour No.
2. Choose an empty location of function by pushing the Joystick up or down.
3. Move the Joystick to left or right to enter the edit mode. Stored Preset view can be recalled
by pressing Preset button, the camera will move to the stored Preset view.
4. To place predefined functions as a Tour, press the function buttons (such as Tour, Pattern,
or Scan, Preset ). Then select function No. by twisting the Zoom handle. (Programmed
function No. will be scrolled). To remove functions from the Tour, press the HOME button,
blank position mark (- - -) will be displayed. You can overwrite the programmed position.
5. Repeat Step 2 through 4 for each desired position. Each title will be displayed on top of the
line.
6. Up to 32 Presets, Tours, Patterns Scans can be selected for a Tour. You can expand the
Tour sequence by calling other programmed tours. Push the Joystick handle to right or left
while the cursor is on the top of the line (TOUR 01) to select another page of the Tour menu.
(TOUR 01)
7. You can enter a title for the selected Tour by twisting the Joystick while the cursor is on the
top of the line (TOUR 01). Rotate the handle clockwise or counterclockwise to scroll through
the alphanumeric characters. Push the handle to the right or left to select the next or
previous digit.
8. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the program
without saving.
Note : Pressing the HOME or OFF Button to delete stored data.
- 19 -