Program and Operation
5.3 PANNING RANGE (MENU => Setup => Panning Range)
When NEXPTZ Camera in installed near a wall or on a corner, panning range(angle) can be
limited with this function by user.
5.4 CALIBRATION (MENU => Setup => Calibration)
Origin Reset
Origin Position Move : Adjust the small amount of position error from re-installation.
Origin Offset
Auto Calibration
5.5 FACTORY DEFAULT (MENU => Setup => Factory Default)
Programmed data go back to initial state as ex-factory.
Panning Range
RIGHT LIMIT
LEFT LIMIT
ENABLE
SWAP RIGHT/LEFT
Save And Exit
Calibration
Origin Reset
Origin Position Move
Origin Offset
Auto Calibration : OFF
Save And Exit
: Calibrate the ORIGIN point.
: DISABLE / ENABLE
: the Camera calibrates automatically when the deviation of camera
position by force or vibration is detected.
Factory Default
Are you sure?(Yes/No)
YES : ENTER KEY
or MENU KEY
NO : ESC KEY
: ---.-
: ---.-
: OFF
: DISABLE
- 31 -