Table 12 Antenna Replacement Procedure - Honeywell XYR 6000 User Manual

6. Maintenance/Repair
6.3. Replacing antenna
Step
1
Honeywell recommends that the transmitter be removed from service and moved to a clean
area before servicing.
2
Loosen the M3 locking set screw on the display end-cap. See item 1 in Figure 11. Unscrew
and remove the front end cap.
3
Loosen the two screws on the display/sensor module. See items 2 in Figure 11.
4
Remove the display/sensor module from the transmitter body and disconnect the antenna
connector from CN2 connector on the display/sensor module. See item 3 in Figure 11.
5
Loosen the locking set screw at the antenna base. Unscrew the antenna from the transmitter.
Remove the antenna and its connector from the transmitter. See Figure 11.
6
Feed the new antenna's connector through the antenna hole to the front of the transmitter. Do
not connect to display/sensor module yet. Lubricate with Silicone Grease such as Dow Corning
#55. Screw new antenna into transmitter body until finger-tight, then back off 180 degrees to
permit adjustment later.
7
Attach antenna connector to CN2 connector on display/sensor module. See item 3 in Figure
11.
8
Insert display/sensor module. Orient in the proper viewing orientation before tightening two
sensor compartment screws. See items 2 in Figure 11. Torque screws to 0,4 – 0,6 N-M (3.5 –
5.3 Lb-in).
9
Replace the front end cap. Honeywell recommends lubricating the front end cap O-ring with a
Silicone Grease such as Dow Corning #55 or equivalent before replacing the end cap.
10
Adjust antenna for best reception. Don't rotate antenna more than 180 degrees either direction
or you could twist and break the antenna wiring inside. Tighten the antenna locking set screw.
28

Table 12 Antenna replacement procedure

OneWireless XYR 6000 Temperature Transmitter User's Manual
Action
Revision 2
8/7/07