Dialer Timer Enable; Dialer Timer Idle - HP VSR1000 Layer 2 - Wan Access Command Reference

dialer timer enable

Use dialer timer enable to set the link holddown timer.
Use undo dialer timer enable to restore the default.
Syntax
dialer timer enable interval
undo dialer timer enable
Default
The link holddown timer is 5 seconds.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
interval: Holddown timer value, setting the interval for originating a call to bring up a link after it is
disconnected. The value range for this argument is 5 to 65535 seconds.
Usage guidelines
A holddown timer starts upon disconnection of a link. The call attempt to bring up this link can be made
only after the timer expires. This is to prevent a remote SPCS from being overloaded.
To make sure the server has enough time to place a return call, the link holddown timer of the client must
be at least 10 seconds longer than that of the server. HP recommends that you set the link holddown timer
to 5 seconds (the default) on the server, and 15 seconds on the client.
Examples
# Set the interval for DDR to make the next call attempt to 15 seconds.
<Sysname> system-view
[Sysname] interface dialer 0
[Sysname-Dialer0] dialer timer enable 15

dialer timer idle

Use dialer timer idle to set the link idle-timeout timer.
Use undo dialer timer idle to restore the default.
Syntax
dialer timer idle idle [ in | in-out ]
undo dialer timer idle
Default
The link idle-timeout timer is 120 seconds, and only outgoing interesting packets reset this timer.
Views
Dialer interface view
32