HP VSR1000 Layer 2 - Wan Access Command Reference page 43

<Sysname> display interface dialer brief down
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Dia1
Table 8 Command output
Field
Dialer1
Current state
Line protocol state
Description
Bandwidth
Maximum Transmit Unit
Internet protocol processing
LCP: initial
Physical
Output queue: (Urgent queuing :
Length)
Output queue: (Protocol
queuing : Length)
Output queue: (FIFO queuing :
Length)
Last clearing of counters: Never
Last 300 seconds input rate
Last 300 seconds output rate
Input: 0 packets, 0 bytes, 0
dropped
Output: 0 packets, 0 bytes, 0
dropped
Brief information on interface(s)
under route mode:
Link: ADM - administratively
down; Stby - standby
Link Cause
ADM Administratively
Description
Physical state of the dialer interface:
•
UP—The dialer interface is physically up.
•
DOWN (Administratively)—The dialer interface was shut down with the
shutdown command. To re-enable it, you must use the undo shutdown
command on it.
Data link layer protocol state of the dialer interface: UP or DOWN.
Interface description.
Intended bandwidth of the interface.
MTU of the dialer interface.
Network layer protocol state of the dialer interface.
LCP initialization is complete.
Physical interface type.
Statistics on the packets in the urgent output queue.
Statistics on the packets in the protocol output queue.
Statistics on the packets in the FIFO output queue.
Time when statistics on the dialer interfaces were last cleared. Never
indicates the statistics were never cleared.
Input interface data rate during the latest 300 seconds.
Output interface data rate during the latest 300 seconds.
Statistics on the packets reaching the interface.
Statistics on the packets sent through the interface.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To recover its
physical state, execute the undo shutdown command.
•
Stby—The interface is operating as a standby interface. To display the
active interface, use the display standby state command (High
Availability Command Reference).
39