Syntax
display pppoe-client session summary
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
dial-bundle-number number: Specifies a dialer bundle by its number in the range of 0 to1023. If this
option is not specified, this command displays summary information about all PPPoE sessions.
Examples
# Display summary information about all PPPoE sessions.
<Sysname> display pppoe-client session summary
Bundle ID
1
1
2
1
Table 2 Command output
Field
Bundle
Interface
VA
RemoteMAC
LocalMAC
State
pppoe-client
Use pppoe-client to establish a PPPoE session and specify the dialer bundle corresponding to the session.
Use undo pppoe-client to remove a PPPoE session.
Syntax
pppoe-client dial-bundle-number number [ no-hostuniq ]
undo pppoe-client dial-bundle-number number
Interface
VA
Eth1/1
VA0
Eth1/2
VA1
dial-bundle-number number
[
RemoteMAC
00e0-1400-4300 00e0-1500-4100 SESSION
00e0-1500-4300 00e0-1600-4100 SESSION
Description
Dialer bundle to which the PPPoE session belongs.
Ethernet interface where the PPPoE session is present.
Virtual access interface created for the PPPoE session.
MAC address of the remote end.
MAC address of the local end.
PPPoE session state:
•
IDLE—Initialization state.
•
PADI SENT—A PPPoE Active Discovery Initiation (PADI) packet
has been sent, and a PPPoE Active Discovery Offer (PADO)
packet is being expected.
•
PADR SENT—A PPPoE Active Discovery Request (PADR) packet
has been sent, and a PPPoE Active Discovery
Session-confirmation (PADS) packet is being expected.
•
SESSION—The PPPoE session is successfully established.
3
]
LocalMAC
State