Interface Dialer - HP VSR1000 Layer 2 - Wan Access Command Reference

Field
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause
Related commands
reset counters interface

interface dialer

Use interface dialer to create a dialer interface. If the dialer interface already exists, you enter the dialer
interface view.
Use undo interface dialer to remove a dialer interface.
Syntax
interface dialer number
undo interface dialer number
Default
No dialer interface is created.
Views
System view
Predefined user roles
network-admin
Parameters
number: Dialer interface number in the range of 0 to 1023.
Usage guidelines
The dialer interface has a fixed baud rate of 64000 bps.
Examples
# Create dialer interface Dialer 1.
Description
If the network layer protocol state of an interface is shown as UP, but its link
is an on-demand link or not present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To recover its
physical state, execute the undo shutdown command.
Protocol connection state of the interface: UP or DOWN.
Main IP address of the interface.
Description of the interface.
Cause of a Down physical link. If the port has been shut down with the
shutdown command, this field displays Administratively. To restore the
physical state of the interface, use the undo shutdown command. Not
connected indicates no physical connection due to absence or failure of a
network cable.
40