Tunnel Name; Tunnel Password - HP VSR1000 Layer 2 - Wan Access Command Reference

When the device acts as an LAC, a change in flow control enable state on the LNS causes the same
change in flow control enable state of L2TP sessions. When the device acts as an LNS, a change in the
flow control enable state on the LAC has no effect on the flow control enable state of L2TP sessions.
Examples
# Enable the L2TP session flow control function.
<Sysname> system-view
[Sysname] l2tp-group 1 mode lac
[Sysname-l2tp1] tunnel flow-control

tunnel name

Use tunnel name to specify the local tunnel name.
Use undo tunnel name to restore the default.
Syntax
tunnel name name
undo tunnel name
Default
The local tunnel name is the device name. For more information about the device name, see
Fundamentals Configuration Guide.
Views
L2TP group view
Predefined user roles
network-admin
Parameters
name: Specifies the local tunnel name, a case-sensitive string of 1 to 31 characters.
Examples
# Specify the local tunnel name as itsme.
<Sysname> system-view
[Sysname] l2tp-group 1 mode lns
[Sysname-l2tp1] tunnel name itsme
Related commands
sysname (Fundamentals Command Reference)

tunnel password

Use tunnel password to configure the key for tunnel authentication.
Use undo tunnel password to remove the configuration.
Syntax
tunnel password { cipher | simple } password
undo tunnel password
23