Setup - Graco HFR Setup And Operation

Setup

Setup
Perform this setup procedure to secure all necessary
machine connections for machine operation.
1.
Locate system.
a. Locate system on a level surface. See Dimen-
sions on page 99 for space requirements.
b. Do not expose system to rain.
2.
Electrical requirements. See Models on page 4
for detailed electrical requirements information.
Installing this equipment requires access to parts
which may cause electric shock or other serious injury
if work is not performed properly. Have a qualified
electrician connect power and ground to main power
switch terminals, see step 4 in this setup procedure.
All electrical wiring must be done by a qualified electri-
cian and comply with all local codes and regulations.
28
3.
Ground system
This equipment must be grounded.
a. System: grounded through power cord. See
step 4 on page 28.
b. Fluid supply containers: follow your local code.
c. Object being dispensed into: follow your local
code.
d. Solvent pails used when flushing: follow your
local code. Use only metal pails, which are con-
ductive, placed on a grounded surface. Do not
place pail on a nonconductive surface, such as
paper or cardboard, which interrupts grounding
continuity.
e. To maintain grounding continuity when flushing
or relieving pressure, hold a metal part of dis-
pense gun firmly to the side of a grounded metal
pail, then trigger gun.
4.
Connect electrical cord to system.
NOTE: See Power Line Voltage Surges information on
page 29.
NOTE: Power cord is not supplied. See the following
table.
3A2797R