Initial System Start-Up; Inserting/Ejecting A Disc; Inserting The Disc; Removing The Disc - Alpine i109ED Owner's Manual

01GB00i109ED-i109AD.book Page 10 Tuesday, October 18, 2016 5:50 PM

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET switch with a ballpoint pen or similar
pointed object.
RESET switch

Inserting/Ejecting a Disc

Inserting the Disc

1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [c Disc].
3
Insert the disc with the label side facing up.
Insert the disc until it is automatically pulled into the unit.
The unit starts to play the disc.

Removing the Disc

1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [c Disc].
The monitor will open. Then the disc is ejected.
When the disc has been ejected part way, take it out.
• Even if no disc is inserted, the monitor will open after touching
[c Disc].
3
Touch [Close], or press any button.
• If the disc does not eject after touching [c Disc], press and hold
c (Eject) for at least 2 seconds.
• Do not apply shock to the monitor when it is open as it may result in
malfunction of the unit.
• The monitor will stop at the set tilt angle when closing.
10
-EN
01GB05i109ED-i109AD.fm
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
monitor tends to become very warm under normal operating
conditions. This is not a malfunction, but care should be taken to
avoid prolonged contact with it.

Adjusting the Screen Viewing Angle

Adjust the screen's angle for better visibility.
1
2
3
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.

Adjusting the Volume

Adjust the volume by pressing
Volume decreases/increases continuously by pressing and
holding
Volume: 0 - 35
1
Disc Slot * For i108ED/i108AD
2
* For i109ED/i109AD

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level to 0 dB.
1
2
Press c (Eject).
The Open/Tilt screen is displayed.
Touch [Up] or [Down] to adjust the desired screen
angle.
The screen angle can be adjusted in 5 stages.
Touch [ ] to return to the normal mode.
1 2
, (or -,+) .
* *
Press to activate the MUTE mode.
Pressing again will bring the audio back to its
previous level.
ALPINE i109ED/i109AD 68-30368Z97-A (EN)
1 2
, (or -,+) .
* *