Setting The Steering Remote Keys; Adjusting The Touch Panel; Setting The Aux Mode; Displaying The Product Information - Alpine i109ED Owner's Manual

01GB00i109ED-i109AD.book Page 23 Tuesday, October 18, 2016 5:50 PM

Setting the Steering Remote keys

Perform the following operations to use steering remote control
function.
Setting item: Key Setup
1
Touch the left key of your selected function. (e.g.
Select POWER)
2
Press and hold the corresponding steering remote
control button (e.g. power button), the changed
signal value of steering remote control appears on
the left key.
3
Touch the right key to capture the setting value, and
then release the steering remote control button.
The changed signal value of steering remote control
4
Repeat steps 1 to 3, and set each button.
When settings have been completed, Touch [
return to the previous mode.

Adjusting the Touch Panel

Adjustment becomes necessary when the display position on the LCD
and the touch position on the touch panel do not match.
Setting item: Screen Alignment Adjustment
1
Touch [Screen Alignment Adjustment].
A confirmation message is displayed.
2
Touch [Start it].
• If you touch [Next time] no adjustment is done, and returns to the
previous screen.
3
Accurately touch the Center of "+" mark more than 1
second at several points.
4
Touch [OK].
This completes adjustment, and returns to the previous
screen.
01GB05i109ED-i109AD.fm

Setting the AUX Mode

Setting item: AUX Select
Setting contents: AUX RCA (Initial setting)/DVB-T/Mini Jack
AUX RCA: Set when an external device with RCA output
connector is connected.
DVB-T: Set when a DVB-T tuner is connected.
Mini Jack: Set when an external device with Mini Jack output
connector is connected.

Displaying the Product Information

You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support or
an Alpine-authorized dealer.
Setting item: About
Contents: Model Name/Main Ver. /Multimedia Ver./Bluetooth ver./
Bluetooth Address
• Touch [Model Name] the Model Name input screen appears, you can
change it according to your own preferences.

Initializing the General Setup

You can initialize all data of General Setup to restore the factory
settings.
Setting item: Clear All Settings
1
Touch [Clear All Settings].
2
After the confirmation message appears, touch
[OK].
The General setting starts initialization.
• Touching [Cancel] will cancel the setting.
] to
ALPINE i109ED/i109AD 68-30368Z97-A (EN)
23
-EN