Basic Operations; Using Face Cover; Initial System Start-Up; Raising The Monitor - Alpine TME-M790 Owner's Manual

Basic Operations

Using Face Cover

An anti-theft face cover is provided with the TME-
M790.
Put the face cover onto the TME-M790 when you
leave the vehicle.
Be sure to remove the anti-theft face cover when
you drive.

Initial System Start-up

Immediately after installing or applying power to
the unit, it should be initialized.
1
At the lower left corner of the screen front panel,
there is a small button. Using a pencil or other
pointed object, press this RESET switch to
complete the initialization procedure.

Raising the Monitor

NOTE
The TME-M790 is a precision device. With careful
handling, its performance can be maintained at a high
level for a long time.
1
Press the OPEN/CLOSE button.
The unit beeps 3 times and raises the monitor
automatically.
4
-EN
9 8
RESET switch PWR
OPEN/CLOSE / -
AUX
NOTES
• If the monitor touches an obstacle while it is
being raised, the unit will stop raising the
monitor immediately. Should this occur, remove the
obstacle and press the OPEN/CLOSE button again to
raise the monitor.
• When the movable monitor is opened, do not place
any object on the monitor and be careful not to bump
or apply any pressure to the monitor while it is open.
This can cause damage to the mechanism.
• Under low ambient temperature conditions, the
display may be dark for a short period of time
immediately after the power is turned on. Once the
LCD has warmed up, the display will return to
normal.
• For your safety, some operation of the unit
cannot be performed while the vehicle is in
motion. In this case, first stop the vehicle and
engage the parking brake, then perform the
operation.

Lowering the Monitor

NOTE
The TME-M790 is a precision device. With careful
handling, its performance can be maintained at a high
level for a long time.
1
Press the OPEN/CLOSE button.
The unit will beep 3 times and lower the monitor
automatically.
NOTE
If the monitor touches an obstacle while it is being
lowered, the unit will stop lowering the monitor
immediately.
Should this occur, remove the obstacle and press the
OPEN/CLOSE button again to lower the monitor.