N.B.: during registering / cancelling new users operations, the fl ashing numbers viewed, are available and usable for any user needing to be registered (
maximum 25 users).
Adding user with associated command
Important! Before entering users, remove the memory roll card if present.
Select U 1.
Press ENTER to confirm.
Select a command to associate to the user.
The commands are:
- step-step (open-close) = 1
- sequential (open-stop-close-stop) = 2;
- open = 3;
- partial opening/pedestrian = 4.
Press ENTER to confirm...
... an available number between 1 and 25 will
flash for a few seconds, this number will be
assigned to the user after the code is sent via
transmitter or other such command device).
Cancelling one user
Select U 2.
Press ENTER to confirm.
2) Use the arrow buttons to select the user num-
ber you wish to cancel.
Press ENTER to confirm...
... CLr will be displayed to confirm cancellation.