Command And Control Devices - CAME BXV06AGL Installation Manual

Maximum capacity of contacts
The total power of the outputs listed below must not exceed the maximum output power [Accessories]
Device
Accessories
Additional light
Flashing beacon
Operator status warning light
The outputs deliver 24 V DC when the batteries start operating, if they are installed.

Command and control devices

1 Antenna with RG58 cable
Insert the AF card into the corresponding connector for remote control with transmitter.
2 STOP button (NC contact)
Stop the gate and exclude automatic closing. Use a control device to resume movement.
If the contact is not used, it must be deactivated during programming.
3 Control device (NO contact)
OPEN ONLY or PARTIAL OPENING function
Fully or partially open the gate.
When the [HOLD-TO-RUN] function is active, the control device must be connected during OPENING.
4 Control device (NO contact)
OPEN-CLOSE (step-by-step) or OPEN-STOP-CLOSE-STOP (sequential) function
When the [HOLD-TO-RUN] function is active, the control device must be connected during CLOSING.
5 Card reader
Insert the R700 card into the corresponding connector.
6 Transponder selector switch
Insert the R700 card into the corresponding connector.
Keypad selector
7
Insert the R800 card into the corresponding connector.
1
Output
10 - 11
10 - E
10 - E
10 - 5
1 2 3P 7
2 3 4
Power supply (V)
24 AC
24
24 AC
24 AC
S1 GND
5 6
Power (W)
40
25
25
-
A B A B GN A B GND B D
7