Installing the gearmotor and transmission arms
Set up the required electrical cables threading them through the cable glands and blocking them to the gate post fastening U bracket. Insert the
gearmotor into the bracket and fasten it with nuts and bolts (
Fit plug
into the gearmotor shaft hole. Fasten the transmission arm to the shaft with slow-shaft washer
Fasten the drive arm to the transmission arm with the pin, bolt and washer (
Release the gearmotor (see paragraph manual release override and block of the gearmotor), fasten the drive arm to the gate bracket as shown in the
drawing(
).
g
).
c
f
h
a
b
and the bolt
d
e
).
g
.
f
i
h