Built-In Printer (Optional); Replacing The Paper Roll; Replacing The Ribbon Cartridge - Miele G 7825 Operating Instructions Manual

Maintenance
Replacing the
paper roll
Replacing the
ribbon cartridge
56

Built-in printer (optional)

A red indicator light behind the front panel of the printer will light up
when the printer roll is finished. Regularly check how much paper is
left on the roll. To change the paper roll do this:
Open the front panel of the printer at the upper edge and then pull it

downwards.
Remove the empty paper roll and spindle together from the holder,

fit the new roll onto the spindle and put back in place.
Guide the paper up and over the paper transport roller (slit behind

the ribbon cartridge). Press the grey paper transport button until the
paper re-emerges above the ribbon cartridge.
Guide the paper through the slit in the front panel. Shut the panel.

Replacement paper rolls (58 mm wide / outer diameter approx. 50
mm) can be purchased from Miele.
Open the front panel of the printer at the upper edge and then pull it

downwards.
The ribbon cartridge is above the paper roll. Pull it forward and out

of the holder and replace it with a new one. The paper must be
guided between the ribbon and the cartridge housing.
Turn the small wheel on the right for manual ribbon transport

clockwise until the ribbon is taut.
Guide the paper through the slit in the front panel. Shut the panel.

Replacement ribbon cartridges can be purchased from Miele.