Operation
42
Door lock
The machine is equipped with an electric door lock.
The door can only be opened when:
– the washer-disinfector is connected to the electrical supply,
– the main switch is in the I-ON position,
– the I-O button is pressed,
– no wash or disinfection program is running.
To open the door on the clean side (G 7826), please also note the
following:
– Disinfection programs must have been completed without fault
according to program parameters,
or
– the INTERLOCK YES function is active.
Opening the door
Press the door switch . At the same time, grip the handle and
open the door.
Do not touch the heating element under the sump filter when
you open the door directly after completion of the program.
They remain hot even for some minutes after the program has
ended and can cause burns.
Closing the door
Lift the door upward and push until it clicks shut.
If Boiler ready has been programmed for the boiler heating,
remember that hot water or steam may escape when the door is
open.
The inlet pipe is below the left-hand basket guide rail, as seen from
the unclean (infeed) side.