Installing The Backplane Connector Shields; Parts List; Procedure - HP E8400A C-Size VXI Mainframe User And Service Manual

Installing the Backplane Connector Shields

WARNING

Parts List

Procedure

38 Rack Mounting and Option Installation
This procedure describes how to install backplane connector shields in the
HP E8400A mainframe. The shields are HP's implementation of VXI
revision 1.4, specification B.7.2.3 which ensures compliance with RFI
levels specified in standards EN55011 and CISPR11.
Note
A number of VXI instruments require shields for compliance with
EN55011 and CISPR11. Refer to the instrument documentation to
determine if shields are required.
Do not install backplane connector shields while the mainframe
is turned on or plugged into an AC power source.
The parts included in Option 918 are shown in Table 2-6.
Table 2-6. HP E8400A Option 918 Parts List.
Quantity
54*
1
26
* Includes two extra screws
1. Position the shields over the backplane connectors as shown in Figure
2-14. Two connector shields and four screws are required for each
slot.
Description
Torx Head Screw - 4-20x.25
Torx Driver
Backplane Connector Shield
Part Number
0624-0702
8710-1989
E1400-80601
Chapter 2