HP E8400A C-Size VXI Mainframe User And Service Manual page 19

WARNING
Chapter 1
1. To prevent damage to the VXI instruments, install the instruments
when power is not applied to the mainframe.
2. Install the HP E1403 A/B-size Module Carrier or the HP E1407
A/B-size Module Carrier into the mainframe. This is done by
aligning the top and bottom of the carrier with the card guides and
slowly pushing the carrier into the mainframe. The front of the
carrier should be even with the front edges of the mainframe.
3. Slide the A- or B-Size instrument into the carrier until it connects.
4. Tighten the retaining screws on the top and bottom of the instrument.
All instruments within the VXI mainframe are grounded through
the mainframe chassis. During installation, tighten the
instrument's retaining screws to secure the instrument to the
mainframe and to make the ground connection.
Using the HP E8400A Mainframe 19