Honeywell VISTA-128BP Installation And Setup Manual page 70

VISTA-128BP/VISTA-250BP Installation and Setup Guide
FIELD TITLE and DATA ENTRIES
Dual Reporting
*51
0 = disable
1 = enable
Standard/Expanded Reporting
*52
Primary
0 = disable
1 = enable
Standard/Expanded Reporting
*53
Secondary
0 = disable
1 = enable
Unattended Mode
*54
0 = disable
1 = enable
Dynamic Signaling Delay
*56
Enter 00-15 times 15 seconds.
Dynamic Signaling Priority
*57
0 = Primary Dialer
1 = Long Range Radio
Long Range Radio Central
*58
Station #1 Category Enable
0 = disable
1 = enable
Long Range Radio Central
*59
Station #2 Category Enable
0 = disable
1 = enable
Zone Type Restores for Zone
*79
Types 1-8
0 = disable
1 = enable
Zone Type Restores for Zone
*80
Types 9, 10 and 16
0 = disable
1 = enable
First Test Report Time
*83
Enter 00-07the for day (01 = Monday)
Enter 00-23 for the hour
Enter 00-59 for the minutes
5-6
WWW.DIYALARMFORUM.COM
EXPLANATION
If enabled, all reports are to be sent to both primary and secondary phone
numbers.
NOTE: If used with Split Reporting option 1 (1*34), alarms go to both primary
and secondary numbers, while all other reports go to secondary only. If used
with Split Reporting option 2, alarms go to both lines, open/close and test
messages go to secondary only, while all other reports go to primary.
This field has six entries as follows: Alarm, Restore, Bypass, Trouble,
Open/Close, Low Battery. If enabled, expanded reports are sent to the primary
phone number if low speed format is selected in field *45.
NOTE: Expanded overrides 4+2 format.
This field has six entries as follows: Alarm, Restore, Bypass, Trouble,
Open/Close, Low Battery. If enabled, expanded reports are sent to the
secondary phone number if low speed format is selected in field *47.
NOTE: Expanded overrides 4+2 format.
If enabled, the system automatically calls the downloader at programmed
intervals.
NOTE: The following fields must be programmed first: primary subscriber
account number – field *32; primary phone number – field *33; downloader
phone number – field *35. Or you can go into the Unattended Program Mode,
from normal operating mode, by entering Installer Code + [#] + [8] + [9].
Select the time the panel should wait for acknowledgment from the first
reporting destination before it attempts to send a message to the second
destination (first and second destinations are determined in field
NOTE: If the acknowledgment is received before the delay time expires, no
message is sent to the second destination.
Select the initial reporting path for central station messages.
This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,
System, Test. If enabled, the reports are sent to the primary subscriber ID of the
Long Range Radio.
This field has six entries as follows: Alarm, Trouble, Bypass, Open/Close,
System, Test. If enabled, the reports are sent to the secondary subscriber ID of
the Long Range Radio.
This field has eight entries, one for each zone type. Select the zone types that
will send Restore reports.
This field has three entries, one for each zone type. Select the zone types that
will send Restore reports.
Enter the day and time that the first Test report shall be transmitted. Enter 00 in
all locations if the Test report is to be sent immediately upon exiting. Enter 00 in
the day location if the report is to be sent at the next occurrence of the time that
is set.
WWW.DIYALARMFORUM.COM
✳
57).