Solid-State Drive - HP ProBook x360 11 G1 Maintenance And Service Manual

Solid-state drive

Description
256-GB, M.2, SATA-3 solid-state drive
128-GB, M.2, SATA-3 solid-state drive
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the bottom cover.
(The solid-state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
28 Chapter 4 Removal and replacement procedures
Keyboard/top cover on page
Battery on page 27).
Spare part number
917099-001
917098-001
18).