Touchpad - HP ProBook x360 11 G1 Maintenance And Service Manual

3. Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable (3) from the TouchPad board.
Reverse this procedure to install the TouchPad cable.

TouchPad

NOTE: The TouchPad spare part kit does not include the TouchPad bracket or the TouchPad cable. The
TouchPad cable is included in the Cable Kit, spare part number 917064-001. The TouchPad bracket is not
spared as a separate component.
Description
In radiant red finish
In smoke gray finish
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see
Remove the TouchPad:
1. Turn the keyboard/top cover upside down with the front edge toward you.
2. Detach the adhesive strip (1) the secures the TouchPad and TouchPad cable to the keyboard/top cover.
3. Release the two pieces of grounding tape (2) that secure the TouchPad to the keyboard/top cover.
Keyboard/top cover on page
Spare part number
917051-001
917052-001
18).
Component replacement procedures 23