Table of Contents
Advertisement
5
Select the [Use SNTP] check box and specify the required settings.
[Use SNTP]
Select the check box to use SNTP for synchronization. If you do not want to use SNTP, clear the check box.
[NTP Server Name]
Enter the IP address of the NTP or the SNTP server. If DNS is available on the network, you can enter a host
name (or FQDN) of alphanumeric characters instead (example: ntp.example.com).
[Polling Interval]
Specify the interval between one synchronization and the next.
6
Click [OK].
7
Restart the machine.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Testing communication with the NTP/SNTP server
●
You can view communication status with the registered server by clicking [Settings/Registration]
Settings]
[Check NTP Server] in [SNTP Settings]. If a proper connection has been established, the result is
displayed as shown below. Note that this operation does not adjust the system clock.
Monitoring the Machine from the Device Management Systems
You can facilitate the collection and management of various information about networked devices by implementing
device management software, such as imageWARE Enterprise Management Console
such as device settings, and error logs is retrieved and distributed via the server computer. If the machine is
connected to such a network, imageWARE Enterprise Management Console searches the network for the machine by
using protocols such as Service Location Protocol (SLP) to gather information from the machine, such as power supply
Setting Up
73
[Network
*
, into the network. Information
Advertisement
Table of Contents
