Table of Contents
Advertisement
6
Open the feeder after the screen displayed during printing disappears.
7
Place the adjustment image on the platen glass.
●
Place the adjustment image with the print side facing down while checking that the black stripe is placed on
the back side of the machine.
8
Gently close the feeder.
9
Select <Start Scanning>.
➠
The placed adjustment image is scanned, and then the second adjustment image is printed.
10
Open the feeder, remove the first adjustment image, and then place the second
adjustment image on the platen glass with the print side face down.
●
In the same way as for the first adjustment image, place the adjustment image with the print side facing
down while checking that the black stripe is placed on the back side of the machine.
11
Gently close the feeder.
12
Select <Start Scanning>.
➠
The adjustment image is scanned and adjustment starts.
13
When a message appears notifying that adjustment is complete, open the feeder,
and remove the adjustment image.
14
Gently close the feeder.
If the <Could not perform correction.> message is displayed
●
Did you load the paper displayed in step 4 into the paper source?
Maintenance
595
Advertisement
Table of Contents
