Using Wps - ZyXEL Communications P-660HN-51 User Manual

4.3.2 Using WPS

This section shows you how to set up a wireless network using WPS. It uses the Zyxel Device as the AP and
Zyxel NWD210N as the wireless client which connects to the notebook.
f your wireless devices display the WPS logo, you can use Wi-Fi
Protected Setup (WPS) to add wireless devices to your wireless network.
The Zyxel Device's WPS function must be enabled before using WPS. Log into Zyxel
Device's web configurator and go to the Network Settings > Wireless > WPS screen. Enable the WPS
function and click Apply.
There are three WPS methods to set up the wireless client settings:
• Method 1- Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• Method 2- Register Wireless Client's PIN Number - Both the Zyxel Device and the wireless client has a
Personal Identification Number (PIN). Enter the wireless client's PIN number and register it on the Zyxel
Device to download the wireless network settings from the Zyxel Device.
• Method 3- Enter AP's PIN Number in Wireless Client - Configure a PIN number on the Zyxel Device.
Enter the Zyxel Device's PIN number and register it on the wireless client.
Method 1: Push Button Configuration (PBC)
Make sure that your Zyxel Device is turned on and your notebook is within the cover range of the wireless
1
signal.
Make sure that you have installed the wireless client driver and utility in your notebook.
2
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button (Start or
3
WPS button).
Chapter 4 Tutorials
P-660HN-51 User's Guide
33